Hard Start Capacitor SPP6 Start Power Pak

Click to enlarge

Price:

$24.75 ()

SKU:

71P48

Condition:

New

Shipping:

Calculated at checkout

Product Description

Quick Overview

Combination relay and start capacitor
One size for any PSC A/C and CSIR units, from 4,000 to 120,000 BtuH
Connect two wires to existing run capacitor for easy installation
Gives additional starting torque to all single-phase 120/288VAC units, from 4,000 to 120,000 BtuH (1/2 through 10 HP)
B11-365 and B11-519 are UR recognized

SKU	71P48
Total Weight	0.7000
VAC	120V - 288V
Note	When identifying the capacitor that you have, you might see the rating stated in "MFD" or "UF." "MFD" and "UF" meaning microfarad rating.
FAQ	How do I know when a capacitor is bad? The air conditioner unit will not come on. Either the outdoor fan does not run, the compressor does not run, or both the fan and the compressor do not run. The breaker on the outdoor unit has been checked and reset, but the outdoor unit still does not come on. You can hear a little humming sound inside the unit which is the low voltage contactor humming. The capacitor may be swollen or even blown apart with capacitor oil.
How To Check	How to Check a Start Capacitor Remove the start capacitor and use a screwdriver to shorten the two terminals and discharge the electricity from it. Set your analog meter on 1k ohms. Touch the two terminals with your ohms meter test leads. Reverse the way that you were touching the two terminals with your ohms meter test leads. The needle in your meter should swing to 0 ohms and swing back to infinity every time that you reverse the ohms meter test lead on the start capacitor. If it does that, the start capacitor is good. Set the meter. On a digital meter, set it to at least 1k ohms. Touch the two terminals with your ohms meter test leads. Reverse the way that you were touching the two terminals with your ohms meter test leads. Notice that the meter will display some numbers for a second. Then it will return to OL (open line). It should do this every time that you switch the ohms meter test leads position. If it does this, the start capacitor is good.